Conservation
Secondary glazing for listed and conservation-area homes
Alex Dukes7 minute readNovember 2026

The short answer. If your home is listed, replacing the original windows needs listed building consent, and councils encourage repair over replacement. Secondary glazing, a slim second window fitted on the inside, is how you make those windows warmer and quieter without changing them. It may still need listed building consent, so speak to your council's conservation officer before you order. In a conservation area that isn't listed, secondary glazing doesn't change the outside of the house, so it doesn't normally need planning permission.
What secondary glazing is
A secondary window is a separate, slim frame fitted inside the original window, usually 100 to 200 mm in from it. The original window stays exactly as it is: same glass, same frame, same paint. From the street you can't see the secondary glazing; from inside it reads as a clean inner frame.
The air gap between the two panes does most of the work. It stops draughts, slows heat loss, and reduces noise from outside. Secondary panes can slide, hinge or lift out, so you can still open and clean the original window.
Listed buildings: consent first
A listed building is protected inside and out. Under the Planning (Listed Buildings and Conservation Areas) Act 1990, you need listed building consent for any works that would affect its character as a building of special architectural or historic interest. Carrying out those works without consent is a criminal offence.
For windows, that means:
- Replacing original windows needs consent, and councils such as St Albans list "changing windows or doors" among the works that do. The same page says like-for-like repairs are encouraged.
- Secondary glazing leaves the original window in place and can be taken out again, so it changes far less than replacement. Whether a particular installation needs consent is still the council's decision. It can depend on how the frame is fixed, and on what's around the window: original shutters, panelling or decorative plaster.
So before anything is made, we'd suggest a short email to your council's conservation officer with a photograph of each window from inside and a note of what you're proposing. Ask whether listed building consent is needed. If it is, the council will tell you what it wants to see in the application.
If you're in Hemel Hempstead, Berkhamsted or Tring, that's Dacorum Borough Council; in St Albans or Harpenden, St Albans City and District Council.
Conservation areas: usually simpler
If your home is in a conservation area but isn't listed, the rules are about the outside of the house. Works that affect only the interior of a building, or that don't materially affect its external appearance, aren't "development" for planning purposes (Town and Country Planning Act 1990, section 55). Secondary glazing sits inside, so it doesn't normally need planning permission.
That's the main reason secondary glazing appeals in a conservation area. Replacing the windows themselves may need planning permission if your council has made an Article 4 direction covering windows, and even where it hasn't, the replacements must be of similar appearance to the originals. Secondary glazing sidesteps that question entirely.
Flats are different: the permitted development rules for windows apply to houses, and a leaseholder may need the landlord's permission for any change. Check your lease.
What building regulations say
Building regulations expect better energy performance when windows are replaced, but they make an exception for historic buildings. Approved Document L says listed buildings and homes in conservation areas don't need to meet the energy efficiency requirements in full where doing so would unacceptably alter their character or appearance (paragraph 0.8). They should still meet them as far as is reasonably practicable (paragraph 0.9).
It also names secondary glazing as the answer. Where windows can't meet the usual standards because the character of the building has to be kept, single glazing should be supplemented with low-emissivity secondary glazing (paragraph 4.10).
Getting it right
Good secondary glazing is close to invisible. These are the details that make the difference:
- Line the frames up with the original. The secondary frame's meeting rail should sit behind the sash's meeting rail, and any vertical divisions behind the original glazing bars, so from outside you see one window, not two.
- Keep the frame slim and the colour quiet. A narrow frame in a colour that matches the inside of the window frame or the walls disappears; a heavy white frame doesn't.
- Choose how it opens. Sliding units suit sash windows; hinged units suit casements; lift-out panels suit windows you rarely open. You'll want to open some windows for air and for cleaning.
- Mind the gap. A wider gap generally does more for noise. Heavier or laminated glass in the secondary pane helps too. Low-emissivity glass is what Approved Document L asks for.
- Think about condensation. The secondary window should be the better-sealed of the two, so that warm, moist air from the room doesn't get into the gap and condense on the cold original glass. The original window can be left to breathe to the outside.
- Fix it without damage. On a listed house, a frame that sits in the reveal or on a discreet sub-frame, rather than screwed through original joinery, is easier to justify and easier to remove.
When secondary glazing isn't the answer
Secondary glazing improves sound windows. It doesn't fix rotten frames, broken cords or sashes painted shut; it just hides them. If the originals need work, talk to a sash repair specialist first. We don't do repairs ourselves, but we'll tell you honestly if that's what your windows need.
If the house isn't listed and the originals are beyond saving, replacement sashes drawn to the original profile can be the better choice, subject to any Article 4 direction. Our guide to replacing sash windows in a conservation area covers that route.
See secondary glazing for how we fit it, and what's covered by our guarantee.
Book a home visit.
Book a home visit and we'll talk through your project at your house — no call centre, no hard sell. We call back within two business hours, and you'll get an itemised written quote.